APL 1A Low Dropout Fast Response Positive Adjustable Regulator and Fixed V, V and V. Features. Guaranteed Output Voltage Accuracy within. APLVC-TU 1A Low Dropout Fast Response Positive Regulator Fixed V and V 1A, Details, datasheet, quote on part number: APLVC-TU. APLUC-TU from Anpec Electronics Corp.. Find the PDF Datasheet, Specifications and Distributor Information.

Author: Goltikora Arall
Country: Switzerland
Language: English (Spanish)
Genre: Technology
Published (Last): 16 January 2007
Pages: 477
PDF File Size: 16.93 Mb
ePub File Size: 7.45 Mb
ISBN: 343-6-33340-188-3
Downloads: 73376
Price: Free* [*Free Regsitration Required]
Uploader: Sakinos

On-chip thermal limiting provides. The output available volt. Basic Adjustable Regulator ues will improve ripple rejection by bypassing the in- put to the regulator.

X C should be approximately. Home – IC Supply – Link. Load Regulation When the adjustable regulator is used. The device is available in an adjustable version and fixed output voltages of 1. The data sheet speci- fication for load regulation is measured at the output pin of the device. A low-ESR solid tantalum capacitor dafasheet extremely well and provides good transient re- sponse and stability over temperature.

The APL output capacitor selection is dependent upon the ESR equivalent series datasheeg of the output capacitor to maintain stability. For fixed voltage devices the top of R1 is internally connected to the output, and the ground pin can be connected to low side of the load. Simplified Application Circuits 1.


For fixed voltage devices the top of R1 is internally. The APL is a low dropout three-terminal apl1117. For fixed voltage devices R1 and R2 are included in the device. The device is available.

The output available volt- age range of an adjustable version is from 1. Proper capacitor selection is important to ensure proper operation.

APL Datasheet(PDF) – Anpec Electronics Coropration

Dropout voltage is guar. By plac- ing a resistor between these two terminals, a con- stant Current is caused to flow through R1 and down through R2 to set the overall output voltage. Best load regulation is obtained.

Datashfet will improve transient response as well as pro. If R1 were con- nected to the load, RP is multiplied by the divider ratio, the effective resistance between the regulator and the load would be: On-chip thermal limiting provides protection against any combination of overload that would create excessive junction temperatures. In order to obtain lower dropout voltage and faster transient response, which is critical for low voltage applications, the APL has been optimized.

The data sheet speci. Dropout voltage is guar- anteed at a maximum of 1.


Результаты поиска для APL1117-AH

Tantalum, or aluminum electrolytic capacitors can be used for bypassing. Load regula- tion will be limited by the resistance of the wire con- necting the regulator to the load.

ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and. Current limit is trimmed to ensure specified output current and controlled short-circuit dqtasheet. When the adjustable regulator is used. This will improve transient response as well as pro- mote stability. X C should be approximately equal to R1 at ripple frequency ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and advise customers to obtain the latest version of relevant information to verify before placing orders.

Normally this current is chosen to be the specified minimum load current of 10mA. Best load regulation is obtained when the top of the resistor divider R1 is tied di- rectly to the output pin of the device, not to the load.